FlightRecord

Ground Stop vs. Ground Delay Program: FAA Flight Restrictions

By Sharon Ben-Moshe · · Updated

When adverse weather or airspace congestion strikes commercial aviation, the Federal Aviation Administration implements specific Air Traffic Management initiatives to prevent airport gridlock. The two most common flight restrictions are Ground Stops and Ground Delay Programs.

While both procedures hold flights on the ground at their departure airports, they serve different operational purposes and carry distinct implications for passenger travel schedules.

What is an FAA Ground Stop?

A Ground Stop (GS) is the most restrictive tactical traffic management tool available to air traffic controllers. When the FAA Air Traffic Control System Command Center issues a Ground Stop for a destination airport, all aircraft scheduled to fly to that airport are prohibited from taking off.

Planes currently sitting at departure gates across the country remain held on the ground. However, aircraft already airborne when the stop is issued continue flying toward their destination or enter airborne holding patterns.

Ground Stops are typically implemented for sudden or severe disruptions:

  • Severe thunderstorms or lightning directly over an airport airfield, forcing ground ramp workers to seek indoor shelter.
  • Zero-visibility conditions, heavy snow squalls, or freezing rain that temporarily halt runway operations.
  • Air traffic control equipment failures, radar outages, or power disruptions at regional En Route traffic control centers.
  • Security incidents, disabled aircraft blocking primary runways, or VIP aircraft movements.

Because Ground Stops respond to dynamic, fast-changing events, they are issued for short windows, usually 30 to 90 minutes, and are updated or extended as conditions evolve.

What is an FAA Ground Delay Program?

A Ground Delay Program (GDP) is a planned strategic management initiative used when an airport's expected arrival demand will exceed its physical arrival capacity over an extended period.

Instead of allowing planes to take off on time and spend hours circling in holding stacks or burning emergency fuel, the FAA controls the flow by delaying departures while planes are still on the ground at their origin cities.

The FAA calculates the reduced arrival rate of the destination airport and assigns each individual flight an Expected Departure Clearance Time (EDCT), known colloquially in aviation as a "wheels-up time":

  • If New York Newark normally handles 45 arrivals per hour, but low cloud ceilings drop the capacity to 28 arrivals per hour, the FAA runs a computer optimization model that meters incoming flights.
  • A United Airlines flight in Chicago scheduled to leave at 1:00 p.m. receives an EDCT of 2:35 p.m.
  • The flight crew boards passengers and waits at the Chicago gate or taxi area so the aircraft can take off at its assigned EDCT slot, ensuring an orderly arrival into Newark without mid-air holding.

Ground Delay Programs usually remain active for several hours or throughout an entire afternoon and evening.

Key differences between Ground Stops and Ground Delay Programs

| Characteristic | Ground Stop (GS) | Ground Delay Program (GDP) |

|---|---|---|

| Primary purpose | Immediate halt on traffic for safety or capacity crisis | Metered pacing to match reduced airport capacity |

| Departure status | Zero departures permitted to destination | Aircraft depart at assigned individual EDCT slots |

| Typical causes | Severe thunderstorms, radar outages, blocked runway | Low cloud ceilings, high surface winds, runway construction |

| Expected duration | 30 to 120 minutes, frequently refreshed | 3 to 10 hours, scheduled across an operating bank |

| Predictability | Low; unpredictable reopening time | Moderate; clear scheduled departure target times |

What passengers should do during FAA ground programs

If your flight status displays a sudden multi-hour delay, check nasstatus.faa.gov on your smartphone:

  • If your destination is under a Ground Stop, airline gate agents cannot tell you when your flight will board because the FAA has not cleared departures. Relax near the boarding gate and watch for advisory refresh times.
  • If your destination is under a Ground Delay Program, ask the gate agent for your flight's EDCT (wheels-up time). This time indicates when air traffic control expects your plane to leave the tarmac.
  • Note that an EDCT can move forward if weather clears earlier than predicted. Never wander far from the gate area, as airlines will board quickly if the FAA assigns an earlier slot.

Frequently asked questions

Can a Ground Stop transition into a Ground Delay Program?

Yes. Air traffic managers frequently issue an initial Ground Stop when severe weather first hits a major hub. Once the squall line moves past and the airport resumes partial operations, the FAA replaces the Ground Stop with a Ground Delay Program to systematically meter the accumulated backlog of delayed flights.

What is an Airspace Flow Program (AFP)?

An Airspace Flow Program is similar to a Ground Delay Program, but instead of regulating arrivals into a specific airport, it meters flights passing through a congested section of high-altitude en route airspace, such as a large line of thunderstorms stretching across the Midwest.

Does an airline control the EDCT wheels-up time?

No. Expected Departure Clearance Times are calculated and assigned directly by the FAA air traffic control mainframe computer based on national airspace capacity and equitable slot distribution algorithms across all participating airlines.

Written by Sharon Ben-Moshe, founder of FlightRecord. All figures are computed from US DOT Bureau of Transportation Statistics on-time data — see our methodology. Past performance describes history, not any guarantee about a future flight.